![]() Heavy Dashed Lines Indicate Single Cutaway Used By Many Luithers. The Dust In A Carcynogyn And Is Very A Very Dangerous Health Risk. Special Precaution: Do Not Inhale Any Of The MOP Dust. Let Dry Thoroughly And Sand Smooth With A Power Sander Or Sanding Sticks, Until The Dot And Fretboard Are Level. If You Do This Do Not Reduce The Edges More Than. Wipe Away The Excess With Your Finger, But Make Sure You Don't Scoop It Out Of The Position Dot Cavity.Ĭertain Luthiers Tune The Top By Making The Top Progressively Thinner As It Reaches The Guitar Edge And Remain Full Thickness At The Top. Now Take Each Position Dot And Work It Down Into Each Filled Hole. Take A Bit On The Tip Of Your Finger And Work It Into Each Dot Hole. Inlay Position Dot Tutorial Mixup Some Ebony Sawdust With 2-part Epoxy Into A Toothpaste Consistency. I've Never Had A Side Crack To Contend With - Besides They Look Really Cool! Chamfer All Edges And Space Around The Top. I Prefer To Use Small Mahogany Side Braces, 6mm Wide x 3.2 mm Thick. A Lot Of Acoustic Guitar Makers Reinforce The Guitar Sides With Cloth Tape, Dipped In Glue And Aheared The The Guitar Sides.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |